My silicone rubber mold results are even better than I had planned!
After these two new molds cured I prepared them for their first resin pour by doing one test pour first. Then I mixed up a batch of Envirotex Lite and added some opaque black pigment from the Castin’ Craft family of colourants.
I let these cure for almost two days.
I had some filing to do. For the piece on the left I wanted to remove part of the angel wings and for the one on the right there was a dangle from her head that I didn’t like.
After filing I pulled out my metallic rub-ons again (see blog post earlier this week).
Coloring is the fun part! I used a brush to give some details into areas my fingers could not reach.
I did use a spray fixative to make sure the colours would be permanent.
Here is one molded lady. I did not want to do anything else to her so I added a pin back and made her a brooch.
The angel lady I turned into a necklace. Can’t wait to wear this!
This week of mold making has been a fun one for me.
I hope you make a mold soon and send us a picture of your results!
That rocks! Your necklace turned out great!
Thanks so much!
Take care,
Looks great!!
Just beautiful!! Coincidentally, today I saw a project on http://www.alphastamps.com/blog/ using glazed resin charlotte dolls. Have you ever made these…not sure what glazed resin is.
beautiful where did you get the molds?