I am always on the lookout for new molds to use with ETI products. Last week I found one that had a several flowers that could be used for so many things. Today, I am sharing a resin floral bracelet.
Materials List:
- EnviroTex® Jewelry Resin
- Iridescent Powder
- Bracelet, pre-made metal
- Crystals, flat back
- Craft brush
- Stir sticks
- Craft sheet or plastic for your work surface
- Lighter
Project Instructions:
Measure out equal parts of the resin and hardener, stir for two minutes.
Pour into a second cup and stir for another minute.
Stir in a small amount of Iridescent Powder, to color the resin. (If you want several colors, divide the resin into a few different cups.)
Use the stir stick to drop the resin into the mold.
Use a lighter to remove any air bubbles that rise to the top. Let dry for 12 hours..
Remove flowers from the mold.
Mix a small amount of Jewelry Resin, as previously shown above. Use a stir stick to drop a small amount into the bezels on the bracelet, place a flower onto the bezel.
Use a craft brush to apply a thin layer of resin onto each flower, placing a crystal in the center of each.
Let dry for 12 hours.
Enjoy!
Leave a Reply